Small shepherd's sundial

Some time ago, I made a simple wooden shepherd's sundial.  It's crude and doesn't work well, but I set it on a lanyard and occasionally use it.  When I decided to use it recently, my wife asked for a small one as a necklace.  Commissioned artwork time!

Since I wanted the sundial to be stylish as well as functional, I thought a bit about materials.  I ended up with a simple design that uses 3/8" copper tubing.  It's the same stuff that you can get at the hardware store for various plumbing jobs, but it's small enough for the task.  I traced out the hour lines using a short python script, and printed them out for use as a guide.

The gnomon is held in a steel cylinder with a slight lip to retain it inside the copper tubing, which has a matching (reverse) lip bored in the end.  You slide the cylinder in from the bottom of the sundial.  Boring the copper was a bit of a problem until I got the boring bit set properly.  I also ended up bursting through the side of the first cylinder because I didn't correctly account for the thickness of the tubing. 

I cut the tubing with a jeweler's saw and filed it to final shape for the noon curve.   The cylinder has two drillings: an axial drilling for the hanging loop and a radial drilling for the gnomon.  The hanging loop is just a piece of brass wire bent into a loop at the top.  I thought of soldering it in place, but decided not to.  I hammered the bottom end of the wire into a small rivet, so the loop is free to turn. 

Here is a trial assembly.

I spent considerable time polishing the copper, the pin, and the cylinder.  The machining was not too arduous, though it did take a few tries, but the engraving was much more tricky.

Here's the final product.

I did not use a watchmaker's square graver (too unwieldy on the round surface) nor the more usual round graver (difficult to get it to bite consistently) to do the engraving.  After a bit of trial on a scrap piece of copper tubing, I found that a very small screwdriver that I had previously sharpened to a narrow cutting blade worked much better for engraving.

To keep everything aligned, I taped the printout to the surface of the copper, and cut through the paper.  This got the copper marked in roughly the right places.  Then I removed the paper and finished the engraving under the microscope.  This took about an hour, and was a bit nerve-wracking because every slip-up is visible.  I'm not too proud of how the engraving came out -- many slips, wiggles, and other awful mishaps are visible if you look closely.  However, it doesn't look embarrassingly bad if you don't use a microscope. 

The sundial certainly looks nice enough on its own, but I am not sure how practical the shiny surface will be in use.  It's cloudy now, which might be for the best!